Boxster S (987) F6-3.4L (2008)
Information
Information: Pay attention to the following in order to remove the support plate without tension:
Lift the vehicle only at the jacking points provided using a uniformly adjusted platform lift. Align lifting arms evenly (in order to avoid distortion).
Overview of rear-axle carrier side section
1 - Rear-axle carrier side section
2 - Diagonal brace
3 - Support plate
4 - Cross member
7 - V-brace
Preliminary work
1. Raise vehicle at the specified jacking points.
2. Remove rear wheel.
3. Remove rear underbody panel.
Removing
Information: Pay attention to the following in order to remove the support plate without tension:
Lift the vehicle only at the jacking points provided using a uniformly adjusted platform lift. Align lifting arms evenly (in order to avoid distortion).
Rear-axle carrier side section disassembled
1 - Rear-axle carrier side section
2 - Diagonal brace
3 - Support plate
4 - Cross member
5 - Sensor
6 - Restraining cable
7 - V-brace