Boxster S (987) F6-3.4L (2008)
Removing clutch pedal
Removing
1. Remove the cover and side trim panel for the fusebox in the left driver's footwell.
2. Carefully pull off the connector from the clutch pedal switch (and interlock switch if necessary) -Arrows-.
Clutch pedal switch
3. Remove the relay carrier, vehicle electrical system control unit, and device support on the left above the clutch pedal.
4. Secure clutch power spring with a cotter pin, for example. Press the clutch pedal lightly, unclip the clutch power spring and remove.
5. Loosen the clutch master cylinder -Arrows- (do not open the clutch system!) and remove the pin (master cylinder valve pushrod).
Clutch master cylinder
6. Loosen bracket for clutch power spring (support for clutch pedal switch and remove interlock switch, if necessary). Carefully move bracket for
clutch power spring approximately 2-4 mm to the left -A-. Carefully turn bracket for clutch power spring clockwise on the pedal bearing axle
approximately 10-15 degrees -B-.