Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-521003.png)
Bracket for clutch power spring
Information: When removing the bracket for the clutch power spring, carefully guide the master cylinder valve pushrod past at the clutch pedal.
7. Pull out bracket for clutch power spring to the left and take out the clutch pedal.
Installing clutch pedal
Installing
Information: Grease bracket in area of pedal bearing axle -Arrows- with Renocal (Glissando VW 745). Part No. 000.043.206.21 (10g tube).
Advanced grease specification
Important: By contrast with previous models, do not grease the pedal bearing axle in the area of the clutch pedal -A- (due to plastic-coated bearing
sleeves).
Also grease the following contact surfaces with Renocal (Glissando VW 745) (Part No. 000.043.206.21): The clutch pedal switch (interlock switch)
system -Arrow-. In addition, the contact surface between the clutch pedal (inside of prongs) -Arrow- and the guiding rods of the clutch power spring
-Arrow-.
Observe correct tightening torques.
Use new lock for bolts.
When installing the bracket for clutch power spring, insert the valve pushrod for the master cylinder carefully into the specified position in the clutch
pedal.
If creaking noises (over approx. 2/3 of the lift area) are heard after installing the clutch pedal, these may be coming from the connection between the
ball head piston rod and piston seat of the clutch master cylinder -Arrow-. In this case, spray a minimal amount of multi-purpose oil on the connection
point using a metering tube -Arrow-. Important: The lubricant must only be applied to this connection point so make sure not to use too much. This
connection point cannot be taken apart without damaging it irreparably.
