Cayenne (92A) V6-3.6L (2011)
2. Mark holes centered through the holes on the holder -Pfeile- and carefully drill through from the inside to the outside using a Dia 6 mm drill bit.
While drilling the holes, remove the drilling chips using a vacuum cleaner.
3. Check hole spacings by fitting roof rail and correct if necessary.
4. Remove roof rail holder.
5. Drill out holes to the dimension -A-. -> Diameter: 20 mm
6. Apply corrosion protection.
Subsequent work
Subsequent work for body repairs (without straightening bench)
1. Clean joint areas and sheetmetal flanges with a wire brush.
2. Prime joint areas and sheetmetal flanges with 2K primer.
3. Restore standard seal with body sealant
Also seal the repair area carefully.
4. Paint repair area and adjacent surfaces, if necessary.
5. Restore standard undersealing with underbody sealant
6. Apply standard cavity preservation
7. Install removed accessories in the repair area.