Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-746003.png)
1. Place the servo motor on the retainer plate and screw down using the fastening screws -Arrows A-. - Tightening torque: 1.0 ftlb.
2. Place the servo motor on the retainer plate and screw down using the fastening screws -Arrows A-. - Tightening torque: 1.0 ftlb.
3. Move the servo motors with the Porsche System Tester to the service position. The drives must be parallel to the guides -Z-.
INFORMATION:
-
Switch on ignition and carry out the service position menu, Drive links menu with the Porsche System Tester in the Climatronic.
-
As an alternative, the servo motors can also be powered with 12 volts until they have reached the correct position. Always use the circuit diagram
for this.
4. Connect the electrical plug connections to the servo motors.
5. Switch off ignition and remove ignition key.
6. Press in plug again and pull apart plug connection.
INFORMATION: Make sure that the drivers of the servo motors are pushed into the mountings.
7. Insert retainer plate with the three servo motors from below into the guides on the air conditioning unit as far as it will go.
