Cayenne GTS (9PA) V8-4.8L (2008)
INFORMATION:
-
The electric lines are located in the plenum panel and are thus exposed to the highest demands.
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the repair kit for harnesses NR.155-1.
-
Crimping samples are to be prepared before beginning work.
16. Crimp crimping sleeve -3- using the hand crimping pliers from the repair kit for harnesses NR.155-1 to the original line from the vehicle electrical
system -2-.
17. Push shrink-fit hose -4- onto the new line -1-.
18. Crimp crimping sleeve -3- using the hand crimping pliers from the repair kit for harnesses NR.155-1 to the new line -1-. Check the crimp
connection carefully.
19. Slide the shrink-fit hose -4- over the crimp connection and carefully shrink it using the hot-air blower with special nozzle (recommended
accessories for the repair kit for harnesses) so that it is watertight.
20. Slide the new line -1- into the Porsche Stability Management control unit connector until the contact is felt to engage.
21. Slide the new ground straps -1- from the repair kit into the Porsche Stability Management control unit connector until the contacts are felt to
engage.
22. Close secondary locking on the Porsche Stability Management control unit connector.