Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-627010.png)
6. Cut away one of the exposed connection points -A- with a side cutters and strip off insulation until no more corrosion can be seen. The leads must
be bright and no longer tarnished or discoloured.
INFORMATION:
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the Repair kit for Cayenne harnesses NR.155-2.
-
Crimping samples are to be prepared before beginning work.
7. Crimp stripped line ends of the connection point using crimping sleeves and the hand crimping pliers from the Repair kit for Cayenne harnesses
NR.155-2.
8. Cut off all other corroded connection points, one after another, strip off the insulation and crimp them again.
9. Insulate all connection points with a suitable shrink-fit hose -A- and carefully shrink them using the hot-air blower with special nozzle
(recommended accessories for the repair kit for harnesses) so that they are watertight.
10. Route main wire harness and fasten with four new tie-wraps. Shorten tie-wraps.
11. Close cover of main wire harness -B-.
12. Fold back carpeted floor -A- on the right side at the entrance.
13. If necessary after moisture leakage, place the vehicle in the drying cabin for 3 - 4 hours (overnight if necessary) at a temperature of approx 60° C.
