Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-628046.png)
33. Connect plug connection to front apron -Arrows A- until locking tab -B- is felt to engage.
34. Place line in installation position -Arrow C- and close clip -Arrow D- until locking tab is felt to engage.
35. Fit ground straps together with twist lock -a- on the threaded bolt (front side member) -Arrow E- and secure with fastening nut -1-. - Tightening
torque: 6.5 ftlb.
Only for vehicles with tyre pressure monitoring system
36. Push connector onto antenna for tyre pressure monitoring system (wheel housing) -Arrow A- until locking tab -B- is felt to engage.
Install front right main headlight.
Install right front wheel housing liner.
Installing main wiring harness - engine compartment in centre
1. Push line through from passenger compartment to engine compartment -Arrow A- until rubber sleeve is felt to engage in firewall -B-.
2. Place line in installation position -Arrow C- and close clip -Arrow D- until locking tabs are felt to engage.
INFORMATION: Before fastening the line to the brake booster, the pressure sensor connector must be connected due to the restricted access.
3. Push connector (brake assist system) onto pressure sensor until locking tab is felt to engage.
4. Turn the line in front of the brake master cylinder to the right and place in the installation position.
