Cayenne GTS (9PA) V8-4.8L (2008)
5. Place line in the holders -Arrows A- and close them -Arrows B- until locking tabs are felt to engage.
6. Place line in installation position -Arrow C- and close clips -Arrows D- until locking tabs are felt to engage.
7. Push connector onto switch-over valve for run-on pump -Arrow A- until locking tab -B- is felt to engage.
8. Push connector onto distance sensor (brake assist system) -Arrow A- until locking tab -B- is felt to engage.
9. Push connector onto brake assist system -Arrow A- until locking tab -B- is felt to engage.
10. Place line in installation position -Arrow A- and close clip -Arrow B- until locking tab is felt to engage.
11. Fit ground strap together with twist lock -a- on the threaded bolt -Arrow C- and secure with fastening nut - 1-. - Tightening torque: 6.5 ftlb.
Install front left plenum panel.
Install wiper motor.
Remove left and rear engine compartment covers.
Installing main wiring harness - engine compartment on left