porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 3504 > < Procedures|Page 3502
Page 68
background image

Remove TV tuner.

Remove control unit for level adjustment.

Remove control unit for trailer hitch.

Remove CD changer.

Remove loudspeaker amplifier.

Remove tilt sensor control unit.

Remove front right side-section trim panel.

Remove floor carpeting from the work area.

Remove right rear wheel housing liner.

1. Lift vehicle.

Only for vehicles with tyre pressure monitoring system.

2. Release connector of antenna for tyre pressure monitoring system (rear wheel housing) -Arrow A- and disconnect it -Arrow B-

3. Loosen the five fastening screws on the carbon canister (tank) and the two on the degassing tank in the right wheel housing -arrows-.

INFORMATION:  In USA vehicles, the rubber hose -1- of the leak diagnosis pump is extremely tight. If the hose is pulled, the filler neck can break
off at the leak diagnosis pump.

4. Release connector on carbon canister -2- and on leak diagnosis pump (USA) -3- and disconnect.
5. Fix carbon canister and degassing tank to the bracket with the fastening screws, but do not tighten.

Procedures|Page 3504 > < Procedures|Page 3502