Cayenne GTS (9PA) V8-4.8L (2008)
55. Push both connectors onto servo motor for rear-differential lock (rear differential) -Arrow A- until locking tabs -B- are felt to engage.
56. Fasten line with a new tie-wrap -C-.
Only for vehicles with off-road stabilizer and/or tyre pressure monitoring system
57. Push connector onto antenna for tyre pressure monitoring system -1- (rear wheel housing) -Arrow A- until locking tab -B- is felt to engage.
58. Connect plug connection for off-road stabilizer -2- -Arrow C- until locking tab -D- is felt to engage. Connect the battery.
Part 1
Removing and installing main wiring harness - floor area and right-hand side
Removing main wiring harness - floor area and right-hand side
General information
INFORMATION:
-
The repair instructions document "Main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
CAUTION:
-
The main wire harness contains all airbag lines, antenna lines and optical waveguides.
-
The main wire harness must therefore not be cut for major repair work and must be replaced complete.
-
If individual lines are damaged, isolate them (disconnect, remove plug contacts from plug connections etc.) and replace the original wire
harness by installing new lines.
Removing main wiring harness - floor area and right-hand side
Disconnect the battery.
Remove Kessy antenna on rear impact member.
Remove right rear light.