Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-628125.png)
17. Push connector onto headlight housing -2-.
17.1. Push connector onto headlight housing -arrow A-, until it is felt to engage.
17.2. Route wire harness and clip in the five retaining clips on the right wheel housing -arrows B-.
18. Push connector on sensor for airbag -1-.
18.1. Push connector onto the sensor for airbag -arrow A-, until it is felt to engage.
18.2. Push line with support onto lock carrier -arrow B-.
INFORMATION:
-
Select a place for the joint where there is enough space to join all the lines present.
-
Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.
-
The electric lines are located in the plenum panel and are thus exposed to the highest demands.
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the Repair kit for Cayenne harnesses NR.155-2.
-
Crimping samples are to be prepared before beginning work.
-
Allocation of lines - see wiring diagram.
19. Crimp lines at -a-.
19.1. Cut off lines in different lengths (due to the shrink-fit connections).
19.2. Slide shrink-fit hoses onto the lines.
19.3. Strip 10 mm of insulation off the wires.
19.4. Crimp the lines with crimping sleeves and the hand crimping pliers from the repair kit for harnesses NR.155-1.
19.5. Slide the shrink-fit hoses over the crimp connections and carefully shrink them using the hot-air blower with special nozzle (recommended
accessories for the repair kit for harnesses) so that it is watertight.
19.6. Wrap commercially available PVC tape all around the area of the connection points.
19.7. Secure the repaired area -b- to the main wire harness with tie-wraps.
Installing intake pipe on the heating/fresh air unit
