Cayenne GTS (9PA) V8-4.8L (2008)
7.4. Clip in electric lines for the generator and oxygen sensor at the heat shield -1- ( -arrows D- ).
8. Secure supply connection piece on generator.
8.1. Grease the new seal on the supply connection piece -2- with Vaseline.
8.2. Press supply connection piece -1- as far as it will go into the supply coolant bore on the generator -arrow- and secure with the new fastening
screw -2-. - Tightening torque: 10 Nm (7.5 ftlb.)
9. Remove hose clamps -3- on the coolant hoses -1 and 2-.
INFORMATION:
-
As of calendar week 42/2008, some screws on the engine were changed to aluminium screws.
-
The impact bracket for the generator has been secured with aluminium screws since then.
-
Observe specifications in the document.
10. Install impact bracket.
10.1. Position impact bracket -2- ( -arrow A- ) and secure with three fastening screws -4-. - Tightening torque: 10 Nm (7.5 ftlb.).
-
Initial tightening: 10 Nm (7.5 ftlb.) and - Final tightening: 90°
10.2. Clip in electric line -3- at the impact bracket -2- ( -arrow B- ).
10.3. Clip in return coolant hose -1- at the impact bracket -2- ( -arrow C- ).
11. Secure ground strap on generator.