Cayenne GTS (9PA) V8-4.8L (2008)
23. Push on connector of lateral acceleration sensor (wheel housing) -Arrow A- until locking tab -B- is felt to engage.
24. Place line in installation position -Arrow C- and close clip -Arrow D- until locking tab is felt to engage.
Only in cars with additional heating
25. Push connector onto circulating pump -Arrow E- until locking tab -F- is felt to engage.
26. Place line to circulating pump in installation position -Arrow G- and close clips -Arrows H- until locking tabs are felt to engage.
27. Push connector onto airbag sensor -Arrow A- until the latch is felt to engage.
28. Push line and holder onto lock carrier -Arrow B-.
29. Insert bulb holder into the light (wheel housing) -Arrow A- with a slight turn.
Only for vehicles with tyre pressure monitoring system
30. Push connector onto antenna for tyre pressure monitoring system -Arrow B- until locking tab -C- is felt to engage.
Install front left main headlight.
Fit front apron.
Install left front wheel housing liner.
Part 1
Removing And Installing Main Wiring Harness - Floor Area And Left-hand Side
Removing main wiring harness - floor area and left-hand side
Overview