Cayenne GTS (9PA) V8-4.8L (2008)
Hydraulic pump connections
The line -2- can only be removed/fitted if the hydraulic pump is raised slightly (approx. 3mm).
1. Insert the hydraulic pump and position the lower line -2- (do not fit).
2. Fit the hydraulic pump.
3. Fit pulley on the hydraulic pump and screw in the screws.
4. Fit drive belt in correct position and tension as required.
5. Tighten the pulley on the hydraulic pump.
Information
Hydraulic pump connections
The M6 thread of the fastening screw for the pressure lines at the hydraulic pump -3- must be cleaned by blowing them out with compressed air before
assembly.
6. Fit the hydraulic lines.
7. Fit the pressure pipe on the turbocharger and on the charge air cooler. Connect positive crankcase ventilation pipe at the pressure pipe and at the
hydraulic pump (not Cayenne S). Position heat shield.
8. Fit intake manifold on the turbocharger (not Cayenne S) and install air cleaner housing.
9. Fit air box for throttle housing (Y-pipe).
10. Fit the air cleaner element and the cover for the air cleaner housing.
11. Fit intake manifold on cover for air cleaner housing.
12. Insert wheel housing liner.
Subsequent work
Information
^
The hydraulic system (steering) must be bled following repairs. Vehicle must be lowered onto the wheels for this.
^
Only use Pentosin(R) CHF 202 to fill the hydraulic systems.
^
Note hydraulic fluid levels.
^
Both hydraulic fluid containers must always be filled (PDCC and steering). The containers must not run dry.
1. Fit the wheel and tighten to the prescribed tightening torque.
2. Fit the engine guard.
3. Fill the two hydraulic fluid containers (PDCC and steering). The fluid level of the two containers must be checked continually during the following
operations.
4. Top off and check the fluid level (PDCC).
5. Bleed the hydraulic system (steering) with the engine running by turning the steering several times to the right or left stop, and adjust the hydraulic