Cayenne GTS (9PA) V8-4.8L (2008)
^
Use an intermediate layer (hard rubber)! Do not damage the brake cover plate.
^
Observe correct tightening torques.
3. Position anti-roll bar and fit clamps and the four fastening screws in vehicle position.
4. Fit the four anti-roll bar fastening screws.
5. Fit the two steel flexi-pipes. The markings must be aligned precisely during installation.
Marking on rear anti-roll bar
6. Fit the connecting links.
7. Following assembly, check carefully once again that the steel flexi-pipes are not twisted! The toothed rings -arrows must be positioned on the steel
flexi-pipes in such a way that they provide adequate protection in the event of contact with adjacent components.
Position of toothed rings (shown on rear-axle)
Subsequent work
1. Install engine guard.
2. Complete the following steps in sequence using the PIWIS System Tester by selecting PDCC >> System replacement >> Replace anti-roll bars
<<.
2.1.
Set valve timing
2.2.
Bleed the system.
2.3.
Carry out a system test.