Cayenne GTS (9PA) V8-4.8L (2008)
14. Press out ball joint of upper trailing arm from wheel carrier using press-out tool T10187.
15. Remove the spring compressor VW 552.
16. Remove brake calliper fastening screws and hang -figure- brake calliper in a suitable place in the wheel housing.
17. Remove drive shaft. To do this, the first fitter must carefully pull the top of the wheel carrier outwards and the second fitter must carefully guide
out the drive shaft.
18. Remove the three mounts for the spring strut in the engine compartment (two mounting points in front of plenum panel and one inside the plenum
panel). The three mounting points -(arrow)- are shown here from inside the wheel housing (wheel carrier installed).