Cayenne GTS (9PA) V8-4.8L (2008)
3. For easy fitting, slightly raise the wheel carrier using a suitable lift so that the upper ball pin can be inserted. Use a suitable lift with rubber base in
order to prevent slipping.
4. Fit securing pin for lower spring strut.
5. Fit connecting link on the anti-roll bar.
6. Fit the holder for the brake line/combination wire at the top on the wheel carrier.
7. Fit the drive shaft at the transmission flange. Remove spring compressor, protective tube and base.
8. Fit the ball joint of the tie rod on the wheel carrier.
9. Tighten plastic nuts on front wheel housing liner.
Subsequent work
Mount wheel.
Rear Suspension
Removing and installing rear spring strut (steel springs)
Preliminary work
Caution
Increased risk of accidents if the wheel carrier is raised improperly!
^
Injuries and material damage are possible.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-> When raising the suspension, use a suitable intermediate layer (hard rubber).
-> Do not damage the brake cover plate.
Remove wheel.
Subsequent work
Fit wheel.