Cayenne GTS (9PA) V8-4.8L (2008)
Pressing in transmission mount
Tool moving freely
5.1.
To do this, place tool T10214/1 under the opening in the transmission cross member. The mount is at the correct installation position when the
tool T10214/2 can move freely.
6. Unscrew tool T10214/3 from the mount.
Unscrewing tool
Information
When pressing in the mount, the mount may not be seated evenly in the transmission cross member.
7. Tool T10214/3 must be repositioned on the projecting side and the mount must be pressed in flush until it is installed evenly in the transmission
cross member.
Subsequent work for transmission mount
Information
Always observe the exact work sequence when installing/removing the transmission cross member.
Information
^
Screws which are tightened with a torque angle must be replaced with new ones.
1. Install transmission cross member.