Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-479005.png)
Overview of cardan shaft
Information
^
The transmission cross member must be disassembled before the cardan shaft is installed.
1. Support transmission with transmission jack.
2. Install cardan shaft between ATF pan and exhaust system support.
Information
^
Screws which are tightened with a torque angle must be replaced with new ones.
3. Screw in new transmission cross member screws -B- on transfer gear holder. -> Initial tightening: 50 Nm (37 ftlb.) -> Final tightening: 90 angular
degrees
Transmission cross member
Information
^
Screws which are tightened with a torque angle must be replaced with new ones.
4. Screw in new cross member screws on body -A-. -> Initial tightening: 50 Nm (37 ftlb.) -> Final tightening: 90 angular degrees
5. Secure exhaust system to transmission cross member -center arrow- and body -outer arrow-. Observe tightening torques for exhaust system.
