Cayenne GTS (9PA) V8-4.8L (2008)
Exhaust system to cross member
Information
Match points of front cardan shaft to front final drive
^
The color markings, match points -arrows- on the cardan shaft and on the all-wheel final drive flange must be aligned. This will neutralize the
residual imbalance of the components.
Information
^
To tighten the cardan shaft bolts, a second fitter should sit in the vehicle and block the drive train by actuating the brake.
Information
^
Screws which are tightened with a torque angle must be replaced with new ones.
6. Mount cardan shaft with new screws. -> Initial tightening: 30 Nm (22 ftlb.) -> Final tightening: 90 angular degrees
Front cardan shaft to all-wheel final drive
7. Mount cardan shaft with new screws -arrow- on the transfer gear. -> Initial tightening: 30 Nm (22 ftlb.) -> Final tightening: 90 angular degrees