Cayenne GTS (9PA) V8-4.8L (2008)
Preliminary work
1. Release fastening nut for drive shaft.
2. Remove wheel.
Tools - Removing and installing front drive shaft
-A- -Universal drive shaft/wheel hub puller as of model '86 NR.87-1
-B- - Protective tube - To protect the drive shaft.
-C- - Press-out tool T10187
-D- - Screwdriver 9546
Removing front drive shaft
Caution
Increased risk of accidents if the wheel carrier is raised improperly!
^
Injuries and material damage are possible.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-> When raising the suspension, use a suitable intermediate layer (hard rubber).
-> Do not damage the brake cover plate.
1. Push (press in) peg into the wheel hub with universal drive shaft/wheel hub extractor as of model '86 NR.87-1. -> Insertion length: 20 mm+5 mm