Cayenne GTS (9PA) V8-4.8L (2008)
2. Remove rear final drive.
3. Release connecting link at top on the side from which the drive shaft is to be removed.
4. Using the universal drive shaft/wheel hub puller as of model '86 NR.87-1, press out peg from the drive shaft.
5. Remove previously fitted tie-wrap. Carefully pull out the drive shaft to be replaced.
Installing rear drive shaft
Information
^
Screws are Dacromet(R) coated and must not be greased.
^
Grease the thread of the axle nut with Optimoly HT.
^
Grease the toothing of the drive shaft lightly with Optimoly HT.
^
To prevent damage to the drive shaft, wheel bearing housing or transmission flange, slide a protective tube (shop made) 00000 over the drive
shaft.
^
Use new screws and lock nuts.
^
Observe correct tightening torques. Tighten the connecting link for the anti-roll bar in three steps (step 1: tighten to 50 Nm (37 ftlb.)/step 2: loosen
by 90 degrees/step 3: tighten to 65 Nm (48 ftlb.)).
^
The parking brake is self-adjusting. If the basic setting of the parking brake is correct, further adjustment operations on the parking brake lever or
on the turnbuckle are not necessary.
^
Always check the bellows for damage and if necessary, replace them, if continuing to use the drive shaft.
Information