Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-471009.png)
^
If the shaft cannot be pushed right in, use assembly fixture T10206 to pull the drive shaft in.
1. Insert the drive shaft and grease the mounting-face ring on the axle nut with a little Optimoly TA aluminium paste. Screw on the axle nut to
prevent the shaft from slipping out. Protect the drive shaft. Tie up the drive shaft with a tie-wrap. This prevents damage to the drive shaft, chassis
subframe and transmission flange.
Subsequent work
1. Push in rear final drive. Connect vent hose.
2. Fit rear muffler.
3. Mount wheel and tighten axle nut (vehicle on ground, also operate the brake - second fitter required).
