Cayenne GTS (9PA) V8-4.8L (2008)
Removing clamps
4. Position inner joint on the ball hub (star-shaped inner ring). Do not put it on the sheet metal part! Press the joint off the profile shaft on a hydraulic
press.
5. Release hose clamps and boots and take them off the profile shaft.
Removing boots
Assembling drive shaft
Caution
Watch out for falling parts during disassembly work.
^
Possible danger of injury or damage.
-> Wear protective gear (e.g. safety shoes, gloves).
-> Get another worker to help.
The drive shaft is assembled in reverse order.
Check all parts to be re-used carefully.
Before fitting the joint, slide all boots, hose clamps and other clamps on to the drive shaft.
Use new circlips and ensure that they are seated correctly.
1. Clamp the drive shaft (use aluminium protective jaws). Position an aluminium mandrel on the ball hub (star shaped inner ring) and fit the joint
-figure- as far as it will go by hitting it several times with a hammer.