Cayenne GTS (9PA) V8-4.8L (2008)
2. Unscrew the two front fastening nuts -7-.
3. Press clip on plug and disconnect electrical plug connection -A- of wiper motor.
3.1. In right-hand drive vehicles, the clip for disconnecting the plug connection is located on the underbody.
4. Unclip engine wire harness to the wiper system 2x.
4.1. Please observe the following points for right-hand drive vehicles: The connector is locked. The catch is located on the underside of the
connector and is not visible from above. To release the catch of the connector, pull the tab on the connector but without undue force on the
connector. This then releases the catch. The connector can now be pulled off.
5. Unscrew four fastening screws -8- on the wiper linkage.
6. Lift wiper motor together with linkage downwards on the driver's side and upwards on the passenger's side. Rotate the entire component and
remove it upwards. Ensure support -B- remains attached to the body.
7. Mark drive position of wiper linkage.
8. Unscrew fastening nut -9- and disengage drive.
9. Unscrew three fastening screws -10- and remove wiper motor.
Installing wiper motor
1. Before attaching wiper motor to wiper linkage, connect wiper motor to electrical plug connection, close bonnet, operate one-touch wipe at least
once and let motor run to the end position. Disconnect plug connection again.
2. Before attaching wiper arms, the wiper motor must be operated a second time at least once with one-touch wipe and run to the end position. Close
bonnet.
INFORMATION: If a new wiper motor is being installed, ensure that the correct Porsche original screws are used.