porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8126 > < Initial Inspection and Diagnostic Overview|Page 8124
Page 23
background image

Telephone/Telematics

The telephone/telematics feature is available as an option and is linked to the PCM2 via the optical waveguide.

Terminating Resistors on the CAN

Terminating Resistors On The CAN

Terminating resistors are fitted to each end of the wiring to prevent reflection on the wiring. These terminating resistors are integrated into each control
unit. The interconnection prevents the resistors from being measured with the ohmmeter from the outside.

Tuner

Tuner

The tuner is part of the PCM2 (on the main board).

Unlock Counter

Unlock Counter

Interruptions occur in the system if perfect communication is no longer possible. If the relevant threshold values are exceeded, an entry is recorded in the
appropriate control unit and the 'unlock counter' is incremented.

Vehicle Hand-Over

Vehicle Hand-Over

The PCM2 is converted into production mode (low-current mode) in production. As known from other systems (alarm system, instrument cluster,
roll-over bar), the PCM2 must be activated with the Porsche System Tester II No. 9588.

1. Connect and start the Porsche System Tester II No. 9588 and switch on the ignition.
2. Select 'Special functions' in the Vehicle type menu and confirm with the >> key
3. Select 'Vehicle hand-over' in the Control modules menu and confirm with the >> key
4. Follow the instructions of the Porsche System Tester II No. 9588.

Voice Control System (VOCS)

Voice Control System (VOCS)

The VOCS is designed as a module box which can be pushed into the PCM2 (optional). After the insertion, an electronic switch is opened and the
module is integrated into the MOST ring.

Wake-Up Function

Wake-Up Function

In an idle state, all control units that are connected to the PCM2/ CDR23 are in sleep mode. When the PCM2/CDR23 is switched on, 'the light' which is
reinforced by the connected MOST control units and forwarded, is switched on via the gateway.

Actual Values

Actual Values

It is possible to read out the unlock counter under the 'Actual values' menu item.

Initial Inspection and Diagnostic Overview|Page 8126 > < Initial Inspection and Diagnostic Overview|Page 8124