Cayenne S (9PA) V8-4.5L (2003)
7. Screw in the extractor tip. Knock out the extractor tip using slide hammer kit 168 in conjunction with the sealing ring.
Installing crankshaft sealing ring on the flywheel side
Warning: Damage to the sealing ring!
^
The sealing ring is provided on a sleeve.
^
Never remove the sealing ring from the sleeve.
^
Never deform or touch the sealing lips.
1. Connect the sealing ring and sleeve to the tool.
2. Position the centering device on the crankshaft stub. Pay attention to the centering pin when doing this. Tighten the two fastening screws to 23 Nm
(17 ft. lbs.).
3. Position the fitting bell and tighten the central screw (a/f 19) to 25 Nm (19 ft. lbs.).
4. Undo the fitting bell and screw it down.
5. Undo the two fastening screws on the centering device and remove the tool.
6. Attach drive plate.