Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1461004.png)
9. Move the servo motors with the Porsche System Tester to the service setting. The drives must be parallel to the guides -Z-.
10. Connect the electrical plug connections to the servo motors.
NOTE:
-
Switch on ignition and activate with the Porsche System Tester in the Climatronic, menu actuator, menu service setting.
-
Alternatively the servo motors can also be fed with 12 volts until they reach the correct position. The wiring diagram must always be referred
to in this case.
11. Switch ignition off and remove ignition key.
12. Press connector again and separate plug connection.
13. Insert retainer plate with the two servo motors from underneath into the guides on the air conditioning box as far as the stop.
NOTE: Make sure that the servo motor drivers are inserted in the mounting points.
14. Connect electrical plug connection -2- until the connector engages firmly.
15. Screw in both fastening screws -1-. Refer to tightening torques.
-
Install relay carrier. Install support on relay carrier.
-
Install network control unit.
-
Install control unit for Kessy or remove control unit for immobilizer.
-
Clip on the instrument panel cover on the left and right.
-
Install the trim under the instrument panel.
Tightening Torques
