Cayenne S (9PA) V8-4.5L (2003)
NOTE:
-
Make sure that the seal -Q- is not damaged. If in doubt, replace.
-
Mount the expansion valve. Refer to tightening torques.
1. Insert the evaporator -P- into the upper half of the housing.
2. Place the upper half of the housing, press it on, and make sure that all three retaining clips engage.
3. Insert heat exchanger into housing and lift up the holding tray, slide the retaining pin through the guide -2- and lock the retaining pin into the
holding tray -1-.
4. Clip right cover and secure with the fastening screws -3-. Refer to tightening torques.