Cayenne S (9PA) V8-4.5L (2003)
1. Remove the plugs on the suction line, check the O-rings and replace if in doubt.
2. Push the suction line onto the connections -arrow- and screw down with both fastening screws -1-. Refer to tightening torques.
-
Fill refrigerant.
-
Mount the side-panel lining at rear.
Tightening Torques
Removing and Installing Vehicle Floor Suction Line (Low Pressure)
Removing and Installing Vehicle Floor Suction Line (Low Pressure)
NOTE: Removing and installing the pressure line and suction line.
Removing The Vehicle Floor Suction Line
Removing the front vehicle floor suction line
-
Remove refrigerant by suction.
-
Observe safety regulations when working with refrigerant. Refer to, Safety regulations for working on air-conditioned vehicles and dealing with
refrigerant R134a.
-
Remove front left wheel.
-
Remove front left wheel housing liner.
-
Remove cover, centre left.
1. Unscrew the fastening screws -2- for the refrigerant lines, close the refrigerant lines -A- (low pressure) and -B- (high pressure), and the
connections with plugs.