Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1203002.png)
1. Place the battery ground strap on the body and secure it with the fastening nut. Tightening torque 20 Nm (15 ftlb.).
2. Lay the floor carpet correctly.
3. Clip in front seat trim (located in the luggage compartment).
-
Carry out work instruction after disconnecting the battery.
NOTE: The battery must be fully charged before handing over to the customer.
Charge battery.
Work Instructions After Disconnecting the Battery
Work Instructions After Disconnecting The Battery
Effect Of Disconnection Or Total Discharge Of The Battery On Electrical Systems In The Vehicle, Subsequent Measures
DANGER:
Risk of explosion, injury, short circuit and damage to the generator and electronic control units.
-
Protective goggles must be worn at all times when working on the battery.
-
Do not disconnect battery with engine running.
-
Disconnect and reconnect battery with extreme caution. Risk of short circuit and explosion.
-
Do not tilt battery when removing it. Risk of causticisation as a result of emerging acid.
-
Do not rub the battery with a dry cloth. Risk of explosion as a result of static charge.
-
All loads must be switched off beforehand.
-
Never start engine without securely connected battery.
-
Do not use a boost charger to start the engine.
-
Whenever possible, use jump leads with overvoltage protection.
-
Always disconnect both battery terminals before carrying out welding work on the vehicle.
-
Only pull off or push on the wiring harness plugs of the control units or other electronic components when the ignition is switched off.
Disconnecting And Connecting The Battery
