Cayenne S (9PA) V8-4.5L (2003)
^
Replace self-locking nuts.
^
Replace all expansion screws (screws which are fitted with torque angle tightening procedure).
^
Use correct tightening torques and torque angle.
1. Fit the anti-roll-bar halves at the previously applied marking on the anti-roll bar. The larger outer diameter of the halves of the anti-roll-bar mount
is on the wheel side.
2. Engage anti-roll-bar mount halves at the take-up points provided -arrow-.
3. Position anti-roll bar and fit clamps with the four fastening screws. Fit connecting rods to anti-roll bar.
4. Tighten the four anti-roll bar fastening screws.
Subsequent work
1. Fit exhaust system.
2. Lower the vehicle.
Removing and Installing Off-Road Stabilizer
Removing and installing off-road stabilizer
Preliminary work
1. Connect the Porsche System Tester and in the menu select >> Off-road Stabi (ORS) >> Drive links >> Clock valve VA or valve HA.
2. Raise vehicle at the jacking points provided.
3. Remove the rear muffler.
Removing off-road stabilizer