Cayenne S (9PA) V8-4.5L (2003)
9. Fit connecting rod.
10. Position -compact connector in wheel well-. Fit holder for brake hose/combination wire at the top of wheel carrier.
Note!
^
Observe torque on residual pressure restraint valve.
1. Fit pressure pipe on -residual pressure restraint valve (arrow)-. Tightening torque: 3 Nm (2 ft. lbs.).
2. Fit ball joint of tie rod on wheel carrier. Tighten -fastening nut- to prescribed tightening torque.
3. Fit wheel. Operate the brake whilst doing so (2 workers required).
4. Fit cowl panel cover and respective side engine compartment lining.
5. Fit windscreen wiper arms.