Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-1429002.png)
^
Tighten all 4 screws for spring strut attachment at top (camper housing top) with specified tightening torque! To do this, use an extension and a
universal joint for the inner fastening screws!
^
The entire threaded parts of the axle must be tightened in vehicle position! Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised with a universal vehicle lift! -Dimension X-, from lower edge of wing to middle of axle 506 mm ± 10 mm corresponds to
vehicle position!
^
Carry out a visual inspection of all parts!
^
Replace self-locking nuts!
^
Replace all expansion screws (screws which are fitted with torque angle tightening procedure)!
^
Use correct tightening torques and torque angle!
1. Insert spring strut into vehicle. When doing this, tighten the rear inner fastening screw (from the damper housing at top) with extension and
universal joint. Tighten all 4 screws with 60 Nm (44 ft. lbs.)!
2. Install lower spring strut attachment with connecting rod. While doing so, use the transmission jack to install the fastening screw. Tighten fastening
screw with the correct tightening torque and torque angle! Do not damage the brake cover plate.
3. Mount wheel.
