Cayenne S (9PA) V8-4.5L (2003)
The clutch slave cylinder -arrow- is located to the left of the transmission, at the center section of the clutch bell-housing (shown here on removed
transmission).
Information
^
Once the lead is separated from the clutch slave cylinder, the clutch pedal must not be pressed until reinstallation is complete.
^
During removal, do not bend the clutch slave cylinder more than 3° from the installation position. Greater deflections of the pushrod can damage
the clutch slave cylinder and cause brake fluid to run into the bellows.
1. Unclip the line -arrow- on the clutch slave cylinder (remove retaining spring) and seal using a suitable plug. Pay attention to the seal on the line.
This can remain stuck in the clutch slave cylinder. Carefully remove the seal and replace with a new one, if necessary.
2. Remove the fastening screw -arrow- on the clutch slave cylinder.
3. Press the clutch slave cylinder carefully outwards -arrow 1-. During removal, do not bend the clutch slave cylinder more than 3° from the
installation position.