Cayenne S (9PA) V8-4.5L (2003)
^
The transmission must be disconnected from the engine when performing this task.
1. Remove transmission.
2. Block drive plate. To do this, attach toothed segment 9538/1 to a screw hole in the crankcase so that at least one tooth is in contact with the starter
teeth.
3. Remove drive plate. To do this, loosen the ten diagonally opposite fastening screws.
4. Take off drive plate.
5. If the drive plate is stuck, it can be hammered down using an internal puller and a slide hammer.
6. To do this, insert the internal puller into the middle of the drive plate and tighten.