Cayenne S (9PA) V8-4.5L (2003)
7. Screw down the slide hammer and hammer down the drive plate.
Note:
^
The crankshaft stub must be cleaned before the drive plate is fitted (remove frictional corrosion).
^
Use a special metal-polishing pad (e.g. Never Dull) to do this.
Installing drive plate for torque converter
1. Fit flywheel.
2. Block drive plate. To do this, attach toothed segment 9538/1 to a screw hole in the crankcase so that at least one tooth is in contact with the starter
teeth.
3. Tighten the ten new M10 x 22 fastening screws crosswise.
Tightening torque: 60 Nm (44 ft. lbs.) + 90°.
4. Remove toothed segment 9538/1 .
5. Install transmission.
Tightening torques