Cayenne S (9PA) V8-4.5L (2003)
5. Press rubber boots into the support and fit safety clips -arrow-.
6. Lift up transfer box with cross member. Position bottom section of gearshift bracket in transmission tunnel -arrow-.
Note:
^
Screws which are tightened with a torque angle must be replaced with new ones.
7. Screw in new fastening screws -A- for transmission cross member.
Transmission cross member to body:
-
Initial tightening: 37ftlb.
-
Final Tightening: 67 Degrees.
8. Screw in two fastening screws to secure exhaust system support to transmission cross member -centre arrows-. Tightening torque: 17 ftlb.