Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Removing rear-axle brake pads
Installing
Installing 18-inch plus brake pads (as of model year 2008)
Warning
Danger of accidents if brake pads of the wrong quality are installed.
Use only the type-specific brake pads.
Do not grease the back of the disc brake pad!
The new disc brakes must be clean and free of grease!
Check disc brakes for wear.
The core of the warning contact wire must not be left exposed! It does not matter if the insulation is worn!
Observe tightening torques.
Installation is in reverse order.
1. Place the brake pads cleanly on the sealing surfaces of the pad retaining springs and fit the brake pads.
2. Fit the brake calliper and route the brake hose.
3. Clip in the wear indicator connector.
4. Position disc brake pads by operating the brake several times.
5. Check the brake fluid level and correct it if necessary. The brake fluid level must be between the -MIN/MAX marking-.
Subsequent work
1. Mount wheel.
Information
Bedding in the brake pads
New brake pads require a bedding-in period of approx. 200 km! Only then do they achieve their best friction and wear coefficient! During this period,