Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Brake Caliper: Service and Repair
Rear
Removing and installing rear brake calliper
Preliminary work
1. Raise the vehicle.
2. Remove the wheel.
Removing rear brake calliper
Removing 18-inch plus brake calliper (Turbo as of model year 2008)
Information
Never use an impact bolter to loosen and tighten the brake calliper on the wheel carrier.
18-inch plus brake calliper
1. Carefully press the brake pads back using water pump pliers.
2. Unclip the brake pad wear indicator wire and press the brake hose out of the fastening clamp.
3. Loosen the brake line from the brake calliper. Collect the brake fluid in a suitable container. Close off the line with suitable stoppers. Remove the
brake calliper.
Installing rear brake calliper
Information
Replace screws and lock nuts.
Never use an impact bolter to loosen and tighten the brake calliper on the wheel carrier.
Pay attention to tightening torques.
The brake calliper is installed in reverse order.
1. Fit the brake calliper.
2. Fit the brake line and cable holder.
3. Clip in connector for wear indicator.
4. Position disc brake pads by operating the brake several times.