Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Removing thermostat with wire loop (tool setup when removed)
1
- Insert a screwdriver, for example, to pull out the insert on the wire.
2
- Wire or electric cable
3
- Intake socket/transfer pipe
4
- Thermostat (coolant regulator)
Pfeil - Removal direction towards radiator
1.2.
Tie a knot in the wire or electric cable to prevent it from being pulled out.
Caution
Pointed or sharp objects
Risk of cracks, pricks or cuts
-
Wear personal protective gear.
1.3.
Pull intake socket/transfer pipe and the thermostat insert out of the crankcase completely using an inserted screwdriver or pliers.
2. With engine removed: Remove intake socket/transfer pipe.
2.1.
To do this, reach into the intake socket using a commercially available internal puller (46 to 56 mm) internal puller Nr.108 Pos.6 and brace it
carefully. -1-
Internal puller inserted in intake socket
2.2.
Remove intake socket with the internal puller. -arrow-
Pulling out intake socket