Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Coolant return line on turbo engine M48/51
1
- Coolant pipe
2
- Coolant hose
3
- Holder
4
- Screw, M6 x 12
5
- Screw, M6 x 20
6
- Connect tab on oil/coolant heat exchanger
B - Clip onto support bracket
A - Direction of travel
3. Loosen the vent line on the cylinder heads.
Vent line
Wire harness for engine
4. Remove screws on the wiring harness on the cylinder heads and at the water guide and loosen the wiring harness.
5. Remove screws on the thermostat housing and loosen thermostat housing in an upward direction. The coolant pipe -1- (bottom figure) remains