Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
Removing and installing guide tube for oil dipstick on DFI engines
Preliminary work
1. Remove intake pipes upstream of the throttle valve.
Removing guide tube for oil dipstick
Removing oil dipstick guide tube
1. Unscrew the two fastening screws. -3 and 11-. Use an angled tool for this.
Oil guide housing with accessories
1
- Guide tube
2
- O-ring
3
- Screw, M6 x 16
4
- Oil dipstick
5
- O-ring
6
- Screw, M6 x 25
7
- Oil level sensor
8
- O-ring
9
- Joint flange
10
- Screw, M6 x 20
11
- Screw, M6 x 16
A - Direction of travel
2. Pull out oil dipstick.
3. Pull guide tube out of the oil guide housing. Carefully turn back and forth if necessary. Check that the sealing ring on the guide tube moves with it
or pull the sealing ring out of the bore using an angled piece of wire.
Installing guide tube for oil dipstick
Information
Illuminate the installation location well for assembling the guide tube.
1. Replace sealing ring.