Cayenne Turbo (9PA) V8-48L Turbo (2008) Wiring Harness Component Information
8. Place air intake housing in installation position -Arrow A- and secure with the two fastening nuts -4-. - Tightening torque: 4.5 ftlb.
9. Fasten air intake housing from the inside with the holders -Arrow B-.
10. Place support for DME control module in installation position -Arrow A- and screw down with fastening screw -2- and fastening nuts -3-. -
Tightening torque: 6 ftlb. - Tightening torque: 6 ftlb.
11. Place line in installation position -Arrow B- and close clip -Arrow C- until locking tabs are felt to engage.
12. Place lines with twist locks (to rear of DME control unit) -a- on the threaded bolts -arrow- and tighten with fastening nuts -1-. - Tightening torque:
6.5 ftlb.
13. Install DME control module.
14. Install plenum panel at front right.
15. Connect plug connection (right of DME control module) -Arrows A- until locking tab -B- is felt to engage.
16. Push plug connection into clip -Arrow C- until locking tab -D- is felt to engage.