Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
2. Lock the secondary locking and check the optical contacts for tightness.
Installing Optical Waveguide
INFORMATION: Observe the general information on optical waveguides.
1. Cut off the optical contacts of the damaged optical waveguide and isolate them.
INFORMATION:
-
The range of spare parts available for optical waveguides depends on the vehicle equipment. Depending on the vehicle equipment, there is a
specific set containing the individual optical waveguides.
-
Select the required optical waveguide and remove it from the set.
2. Route the new optical waveguide along the main wire harness, guide it through the existing cable ducts and tie it to the main wire harness using
tie-wraps.
3. Connect the connectors for the new optical waveguide to the affected parts until the connectors are felt to engage. The illustration shows the
connector on the CD changer as an example.
4. Read out fault memory and erase if required.
5. Check operation of audio components.
Subsequent Work
Install components for releasing main wire harness around floor area and right-hand side.
Install components for releasing main wire harness around dashboard area and centre console.