Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
7. Re-install the cardan shaft between the front-wheel drive and transfer gear. When doing so, make sure that the main catalytic converter is also
positioned above the transmission cross member along with the cardan shaft.
8. Tighten the screws used to secure the catalytic converters to the body and transmission support to the specified tightening torque. - Tightening
torque: 23 Nm (17 ftlb.)
9. Fit the exhaust clamps. For details of installation position and tightening torque,
10. Install the transverse strut. Screw in screws -arrows- (don't forget the centre screw.). - Tightening torque: 10 Nm (7.5 ftlb.)
Installing main catalytic converter on cylinder bank 5 to 8