Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
3.2. Insert expanding pins -1- and press them in -arrows C-.
INFORMATION: Only for vehicles without auxiliary air conditioner.
Position package box -2- on the body -arrow- and secure with the fastening screws -1-.
Setting parameters
INFORMATION:
-
Parameters must be set after replacing the control unit for ParkAssist.
-
During parameter setting, it is essential to guarantee the power supply for the Porsche System Tester. It is essential to connect a battery charger
with a current rating of at least 40 A to the vehicle battery.
-
The Porsche System Tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed.
Deviations may occur with later software versions.
-
The procedure described here has been structured in general terms; different texts or additions may appear in the Porsche System Tester.
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on the ignition. Press >> to continue.
2. Select vehicle type using the cursor keys.
3. Using the ?| key, move from the vehicle type to the control units. Perform an automatic control unit search.
4. Select "ParkAssist" with the cursor keys and press >>.
5. Select "Parameters" with the cursor keys and press >>.
6. Select "Country version" and press >>.
7. Select "Spare wheel version" and press >>.
8. Tester confirms "Parameter setting was successful".
9. Quit the menu.
Subsequent work
1. Install side trim panel for rear left luggage compartment.