Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
10. Remove tie-wrap -arrow- at connector.
11. Release contact strips on both sides of the connector housing -1- ( -arrows a- ) and pull the contact strips -2 and 3- out of the connector housing
-1-.
12. Remove binding band on wire harness and push contact strip -2- down off the contact strip -3-.
INFORMATION: Use the airbag wiring diagram for assigning the airbag lines.
13. Release contact of the damaged airbag line using the press-out tool 1575-1P from the press-out tools set for Cayenne NR.155-3 (-arrow a-) and
pull out of the contact strip.
Install new airbag line
14. Connect connector for the new airbag line to the affected components until the connector engages securely. The illustration shows the connector
on the acceleration sensor under the seat as an example.