Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
INFORMATION:
-
The repair instructions document "Removing and installing main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
CAUTION:
-
The main wire harness contains all airbag lines, antenna lines and optical waveguides.
-
The main wire harness must therefore not be cut for major repair work and must be replaced complete.
-
If individual lines are damaged, isolate them (disconnect, remove plug contacts from plug connections etc.) and replace the original wire
harness by installing new lines.
Removing Main Wiring Harness - Engine Compartment
Removing main wiring harness - engine compartment on left
Remove left front wheel housing liner.
Remove left front main headlight.
Remove front apron.
1. Push in latch -b- on connector for sensor -a- until it is felt to engage -Arrow A-.
2. Release locking mechanism latch -b- -Arrow B- and pull connector off the sensor -a- -Arrow C-.
3. Remove line together with lock carrier support -Arrow D-.
4. Turn bulb holder (wheel housing) slightly and remove -Arrow A-.
Only for vehicles with tyre pressure monitoring system.
5. Release connector on antenna for tyre pressure monitoring system (wheel housing) -Arrow B- and disconnect it -Arrow C-.